Jbl SCS-SAT500 User Manual download pdf (Page 5)

4

Important Safety Note:

The

customer is solely responsi-

ble for proper selection of

mounting hardware not

included with the speaker,

and for proper assembly

and installation of the wall-

mount bracket, including but

not limited to the selection of

appropriate weight-bearing

supports and proper use of

the bracket. JBL disclaims

any liability for the selection

of mounting hardware

and/or bracket installation.

Be sure to follow these

bracket assembly and

installation instructions

carefully. If you have any

questions or doubts about

your ability to correctly wall-

mount the speakers, consult

your authorized JBL dealer

or custom installer.

Step 1: Unscrew and remove

the large Molded Nut ™. If

necessary, use the supplied

Metal Bar ∞ as a lever by

inserting it into one of the

holes in the outer edge of

the Molded Nut ™.

Step 2: Firmly grasp the Ball

and Shaft £ and pull it

straight out of the Attach-

ment Plate ¢. Avoid leaning

it to the side for leverage, as

this may break off a tab.

Step 3: Slide the Molded Nut

™ onto the Ball and Shaft

£ with the threaded open-

ing facing the ball. Thread

the Metal Nut ¡ all the way

onto the Ball and Shaft £,

with the star washer side

away from the ball. Refer to

the exploded drawing for the

proper orientation of these

parts.

Step 4: Screw the Ball and

Shaft £ into the Threaded

Insert § on the back of the

Satellite Speaker ¶ until it

is fully seated in the Threaded

Insert §, but

do not

tighten,

as you might dislodge the

Threaded Insert §. Such

damage would not be cov-

ered under the warranty.

Step 5: Tighten the Metal Nut

¡ with

the star washer side

between the Metal Nut ¡

and the back of the

Satellite

Speaker ¶

, using large

needle-nose pliers until it is

firmly seated against the back

of the Satellite Speaker ¶

and has locked the Ball and

Shaft £ and the Satellite

Speaker ¶ together.

NOTE: Once the Metal Nut ¡

is fully tightened, it may embed

some marks on the back of the

Satellite Speaker ¶. However,

these marks will

be covered

by the

Metal Nut ¡

.

Step 6: Mount the Attach-

ment Plate ¢ into a wood

stud on the wall, using four

#10 panhead wood screws

• at least one inch long

(not supplied). Make sure

that all four screws are

driven into the stud and not

into drywall.

If the bracket

needs to be mounted in

drywall, the customer is

responsible for selecting

and using appropriate wall

anchors and screws.

IMPORTANT NOTE: The Metal

Nut ¡ must be fully tight-

ened against the Satellite

Speaker ¶ as described in

Step 5 before beginning Step

7, in order to avoid damage

to the Threaded Insert §.

WALL-MOUNTING

1

2

3

4

8

5

1

2

3

4

5

6

7

8

SCS-SAT500,300,200 OM 4/25/07 11:39 AM Page 6

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments