Jbl SCS-SAT500 User Manual download pdf (Page 4)

3

Prepare the speaker wire as

described on Page 5. Thread

the two conductors through

the two holes in the stand

bracket. Make sure to pre-

serve the proper polarity

(+ and – connections) by

threading the positive con-

ductor through the hole on

the left, and the negative

conductor through the hole

on the right looking at the

stand from the front. Push

down on the red speaker

terminal and insert the bare

end of the positive wire into

the hole under the red cap.

Release the cap, and tug

gently on the wire to make

sure that the connection

is snug. Follow the same

procedure to connect the

negative wire to its terminal.

Use the larger screw

(Hardware Bag A) in the

upper screw hole, and the

smaller screw (Hardware

Bag A) in the lower screw

hole.

ATTACHING THE SHELF STAND TO THE SPEAKER

+

–

Gently pull the slack out of

the wire and screw the shelf

stand onto the back of the

speaker in two places, as

shown.

MOUNTING THE SATELLITES ON OPTIONAL FLOOR STANDS

Important Safety Note:

The

supplied floor stand adapters

facilitate installation with a

variety of general-purpose

floor stands available from

many manufacturers. Since

different stands will have

different weight capacities

and stability characteristics,

it is the customer’s responsi-

bility to check with the stand

manufacturer or dealer to deter-

mine whether that specific

stand is capable of handling

the weight and proportions

of these loudspeakers in a

safe and stable manner. JBL

disclaims any liability for the

selection of suitable floor

stands and/or correct

compatibility between the

selected stand and these

satellite loudspeakers.

The floor stand adapters are

compatible with floor stands

equipped with a 1/4"-20

threaded insert.

Prepare the speaker wire as

described on Page 5. Thread

the two conductors through

the two holes in the floor

stand adapter. Make sure to

preserve the proper polarity

(+ and – connections) by

threading the positive con-

ductor through the hole on

the left, and the negative

conductor through the hole

on the right (looking at the

front of the adapter). Push

down on the red speaker

terminal and insert the bare

end of the positive wire into

the hole under the red cap.

Release the cap, and tug

gently on the wire to make

sure that the connection

is snug. Follow the same

procedure to connect the

negative wire to its terminal.

Gently pull the slack out of

the wire and screw the adapter

onto the back of the speaker

in two places, as shown.

The floor stand adapter screws

may be found in Hardware

Bag B. Use the larger screw

in the upper screw hole, and

the smaller screw in the

lower screw hole.

Screw the floor stand

adapter into the floor stand’s

threaded insert until the

speaker is firmly attached to

the stand. Back off slightly

from the fully tightened

position until the speaker

is oriented as desired, then

rotate the thumbwheel at

the bottom of the floor stand

adapter to secure the

speaker to the stand.

+

–

SCS-SAT500,300,200 OM 4/25/07 11:39 AM Page 5

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments