JBL Century Gold User Manual

LIMITED EDITIONLOUDSPEAKER SYSTEMCentury GoldA NEW STANDARD FOR A NEW CENTURYfinal cg om 5-15 7/20/98 1:15 PM Page 14

The Century Gold loudspeakers can be connected by one of severalmethods. The binding posts on the rear panel of the Century Goldwill accept most types

The Century Gold’s outer connection panel and internal dividing network are designed so that separate sets of speaker cable can be attachedto the low-

Figures 8 through 10 show two bi-wiring options, single stereo amplifierand dual stereo amplifier modes. For passive and bi-wire connections, setthe swi

The optimal method of powering the Century Gold system is withtwo amplifiers, one for low frequencies and one for the mid/high frequencies.It is necess

The Century Gold loudspeaker systems have an oiled finish. Cleaningshould be done with an untreated dust cloth. Do not use conventional furniture waxes

No.13Frequency Response: 50Hz – 20kHz ±1.5dB38Hz – 22kHz – 6dBSensitivity: 90dB for 2.83V @ 1 meterRecommended Maximum 200 watts continuousPower Hand

Introduction 2Low-Frequency Transducer 3Mid-Frequency Transducer 4High-Frequency Transducer 4Dividing Networks 5Battery Replacement 6Placement 7Speake

This certifies that this Century Gold is a Limited Edition Reference Bookshelf Loudspeaker System,in celebration ofJBL’s 50th Anniversary.Genuine JBLGr

JBL is part of the Harman International family of audio companies, a groupwith a common purpose: combining technology with a love of music tomanufactu

JBL wishes to thank you for selecting the Century Gold loudspeaker system. While the Century Gold loudspeakers are a new development,the ideas behind

No.3The Limited Edition Century Gold Bookshelf Loudspeakers set a newstandard for a new century. JBL combines the most advanced technologywith a class

The Century Gold also features an all-new 5" (127mm) mid-frequencytransducer developed specifically for the Century Gold (Figure 2). Thevoice coil

The job of the dividing network is to distribute the various frequencies totheir respective transducers. The network is also designed to complementcom

The battery should be replaced approximately every 2 years. This isaccomplished as follows:• Unscrew the two screws that hold the battery access cover

Ideally the systems should be placed at least three feet from any walls. Theheight, at the top of the midrange, should be at ear level. The two speake