Jbl HTI88 User Manual download pdf (Page 8)

8

HTI88

EXISTING CONSTRUCTION

The grille is packed separately

from the speaker. If at some

later date you wish to remove

the grille from the speaker, to

avoid scratching the grille or

baffle you may unfold a paper

clip, insert the straight end

through one of the holes in the

grille, and gently pull up.

Determine the correct speaker

location.

Template

Level

Note: Always allow at least

one-half inch between a wall

stud and the speaker cutout, or

the locking tabs will not be able

to swivel into place.

1/2"

1/2"

1/2"

Cut the drywall. Connect the speaker wires to

the speaker as described on

pages 4–7.

Replace the metal grille. Attach

the JBL logo to the grille to cor-

respond to vertical or horizontal

installation.

Place the frame assembly in the

wall until the frame surface is

flush with the wallboard.

Screw down each of the ten

Phillips-head screws. It is best

to use a low-speed cordless

driver or a hand-held screw-

driver to tighten the screws to

prevent over-tightening. The

locking tabs will swivel into

place and secure the unit to the

rear surface of the drywall.

Notes:

• Use the cardboard template

when cutting the drywall.

Although the HTI88 may be

oriented either horizontally

or vertically, the installation

procedure is the same.

• Please be aware the template

is slightly oversized to allow for

some margin of error when

cutting with the drywall saw –

there should be no need to

allow for further margin of error

as this may risk the integrity of

the installation.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments